These Foam Pump(KEXON) work by mixing liquid-thin soap […]
These Foam Pump(KEXON) work by mixing liquid-thin soap and air, and turning it into foam. Check out these recipes for correct dilution. Note that using extra Castile soap will not produce a thicker foam, it will only clog your mechanism faster, causing it to ‘stick’.
Don’t use your pump under running water or overfill bottles.If water gets into the air chamber it may cause the pump to fail.
Don’t seal the bottle too tightly.This may affect performance, and you’ll start seeing the actual bottle creating suction. Loosen lid and continue using.
Keep your pump active.If you don’t use your foaming pump frequently enough, any soap trapped in the mechanism can dry and cause the pump to stick or fail.
Try flushing the pump in fresh water.Just remove the pump top and place in a glass of water. Keep pressing until clear water is being dispersed. Then try again with your bottle.
Don’t use additives beyond TILP recipe suggestions.There is a little mesh screen inside your pump that allows the soap and air to mix, creating foam. These holes are so super tiny, and they can clog easily. Therefore, adding thickeners, glitter, micas, powdered colouring etc, will cause your mechanism to fail.
Ningbo KeXon Plastic Co., Ltd. is a comprehensive plastic packaging enterprise integrating design, production, and sales. We own a factory (Yuyao KeXon Sprayer Factory), and its plant area is over 6,000 square meters, with more than 20 years of production experience in various types of daily packaging. The company can professionally produce all kinds of foam pumps, plastic caps, daily and medicinal plastic bottles, as well as all kinds of trigger sprayers, lotion pumps, perfume sprayers, cream jar and other products.